Two-Stage Mechanical Oscillator Pendulum-Lever System: A Mechanical Amplifier of Clean Energy

Authored or posted by | Updated on | Published on April 3, 2017

Picture of Two Stage Mechanical Oscillator Pendulum Lever System

By VeljkoMilkovic.com

Free Mechanical Energy Device
– The Simplest Technology –

A Top 100 Energy Technology in 2006 (by New Energy Congress)

A simple mechanism (Figure 1.) with new mechanical effects, represents the source of clean energy. This gravity machine has only two main parts: a massive lever and a pendulum. The interaction of the two-stage lever multiplies input energy into output energy convenient for useful work (mechanical hammer, press, pump, transmission, electric generator…). *watch the video presentations for the full insight in this research – click here


Figure 1. Mechanical hammer with a pendulum
1 – anvil, 2 – massive lever, 3 – lever axel, 4 – physical pendulum

The best results were achieved with the lever axel and pendulum at the same height, and the base of the massive lever above the centre of mass, as shown in Figure 1.

ORIGINS OF ENERGY BASED ON DIFFERENCE IN POTENTIAL

Energy is created due to the difference in existing devices. Consumers of energy use the difference in the potential between the plus and the minus (direct current) and zero and the phase (alternate current). All heat and thermal motors accomplish useful work due to the higher temperature and pressure. Mills and power plants use different levels of water…

However, difference in the potential of two-stage oscillator, “unusual machine” has not been considered so far.


Figure 2. Difference of the potential during oscillation of the physical pendulum
1 – weightless state in the upper position
2 – culmination of force during the fall in the lower position

Since there is a difference in potential (Figure 2.) between the weightless state (1) and culmination of force (2) during oscillation of the pendulum, the same is true for centrifugal force, which is zero in upper position, and culminates in the lower position at maximum speed. Physical pendulum is used as a single-stage oscillator in the system with a lever.

After many years of trials, consultations and public appearances, it could be said that this occurrence is being researched and investigated all over the world (author is in possession of evidence). Simplicity enables construction of houses by owners themselves.

Efficiency of the model can be increased by mass, since the relationship between the volume of the lever weight and its surface increases the mass.

Energy Measuring

It is important to note that we are not supporting over unity claim for the oscillator where its pendulum was initially raised to some height and then left to swing until it stops.

Our idea is that after initial raising of a pendulum it is necessary to keep adding a little energy to a pendulum to keep it swinging. Because two stage oscillator is supposed to be used for long period of the time, energy spent for initial raising can be disregarded. The same logic is for Diesel engines where it is necessary for them to achieve working temperature before measuring its efficiency. Nobody would also include energy spent for magnetization of permanent magnets in an electric motor for calculation of efficiency ratio of his electric motor.

It is necessary to measure small energy continuously added to maintain pendulum swinging. Note also that output force on the lever side is variable and change from zero to a maximum defined by its mass. The reason for it is variable force of the pendulum which exert pulling the lever on opposite side. This makes mathematics complex and precise tools for measuring variable force are necessary for calculation of efficiency ratio of a two stage oscillator.

The well known fact is that pendulum with fixed pivot point can keep swinging for several hours. Two-stage oscillator has movable pivot point. It moves in rhythm of the lever which frequency is double higher than frequency of the pendulum. The movement of the pivot point, or better to say its acceleration, keeps spending energy of the pendulum which decelerates its swinging fast. Friction in pendulum pivot point is very small in comparison with losses due to movement and acceleration of the pivot point and can be disregarded. Oscillators with small and harmonic movement of the pivot point have better performances and that is the reason why special attention should be given to that problem.

Mechanical Fission

Two-stage mechanical oscillators should be set in accordance with geometry progression system, by which mechanical chain reaction could be achieved: 1<2<4<8< oscillators…

This could be the best way to confirm the overunity effect and accomplish replacement for nuclear fission.


Figure 3. Experimental models

Extreme technical solutions can be tourist attractions even as prototypes.


Figure 4. Two-stage mechanical oscillator as a tourist attraction

Previous examples emphasize the importance of synchronized frequency with every model. Oscillations of the physical pendulum have to be maintained with certain speed, otherwise input energy is wasted.

Mechanical hammer (photo & video) and a pump with a pendulum (photo & video) work more efficiently with a shorter pendulum, but with air movement (educational toy – photo & video), longer pendulum works better.

According to the theory of oscillation, oscillatory movements in nature are the most frequent ones, and can be difficult to analyze.

Preposition for decreasing of the friction

Two-stage mechanical oscillator or some other gadget lay in direction east-west in order to decrease axial friction on bearings caused by Coriolis force.

POSTULATES AND DOGMAS

The easiest way is to proclaim something as impossible and refer to laws. However, are all laws of Physics perfect and eternal? Luckily, and most probably, they are not. Therefore, exceptions of extremely efficient machines are possible (Fig. 1-3.).

In the same way, the speed of light can be deemed unreachable, according to Einstein’s formula E=mc2, because the mass would be infinite. However, the mass does not change with speed, and the kinetic energy increases with the square speed. Therefore, the speed of light can be reached by future space crafts, if these ideas are considered.

To someone it is a problem if the idea was simple, but coming to the simple solution is the hardest and there are the most reasons for that.

POWERFUL PENDULUMKNOW-HOW

After many years of research optimal solutions are tested on a prototype and a sophisticated and ultra efficient pendulum has been found applicable to fitness centers (New Sport for Clean Energy – Possibility of Practical Application) and can also be used as a mechanical amplifier for alternative energy (wind power, hydropower …).

Besides that, there are new advanced technical solutions (like various magneto-gravitational hybrids) and other know-how solutions in the same area which have immense application width.

For more information, please contact the author Veljko Milkovic.

REPLICAS FROM INDIA

[Hand Water Pump With a Pendulum]

[Pendulum Operated Water Pump]

New official measurement

Oscillations more efficient than rotations

Laboratory proof of the superiority of the flexible pendulum versus the electric motor

Laboratory measuring which proves the oscillation of a flexible pendulum to be a hundred times longer than the rotation of an asynchronous motor

measurement performed by Prof. Slobodan Milovancev, Ph.D., Faculty of Technical Sciences, University in Novi Sad, Serbia, June 04, 2014

Read full article

Share Button


Category: Free & Alternative Energy

Comments are closed.